BATTERY 1526065 - Caterpillar

Illustration 1 g03134556
Rear view
Illustration 2 g03134557
View of area A
Illustration 3 g03134636
View of area B
Table 1
Specification for 112-3441 Rear Gear Gp    
Item     Qty     Part     Specification Description    
1     2     5P-8429 O-Ring Seal     Before assembly, lubricate the bore lightly with the lubricant that is being sealed.    
2     2     5P-1370 Roller Bearing As     Before installation, bore is
82.550 mm (3.2500 inch).    
3     1     5F-7404 Bearing Locknut     Use the following procedure in order to tighten the bearing locknut:
1. Tighten the bearing locknut to
406 68 N m (299 50 lb ft).
2. Bend the tab on lockwasher (4) which aligns with the slot of bearing locknut.    
Illustration 4 g03134637
View of area C
Illustration 5 g03134638
View of area D
Table 2
Item     Qty     Part     Specification Description    
5     1     2W-7615 Idler Gear     Before installation, bore in the idler gear for the roller bearing assembly is
129.931 0.013 mm (5.1154 0.0005 inch).    
6     2     6V-7423 Roller Bearing As     Before installation, bore in the roller bearing assembly for idler gear shaft is
84.98 to 85.00 mm (3.346 to 3.346 inch).    
7     2     4N-1235 Idler Gear Shaft     Diameter is
84.952 0.010 mm (3.3446 0.0004 inch).    
8     1     2W-7611 Balancer Gear     Install the balancer gear with the timing mark "V" toward cylinder number one at top dead center.
Before installation, bore in the balancer gear for the roller bearing assembly is
129.931 0.013 mm (5.1154 0.0005 inch).    
Illustration 6 g03134639
View of area E
Table 3
Item     Qty     Part     Specification Description    
9     1     2W-7614 Crankshaft Gear     Install the crankshaft gear with the timing mark "V" toward cylinder number one at top dead center.    
10     1     4N-0684 Dowel     Protrusion of the new dowel is
6.5 2.0 mm (0.26 0.08 inch).    
11     1     4N-0848 Wear Sleeve     Installation depth is
1.5 0.5 mm (0.06 0.02 inch).