AVSPARE.COM
parts catalog

BATTERY 2500480 - Caterpillar



2500480 BATTERY Caterpillar parts BATTERY
Rating:
16
Alternative (cross code) number:
CA2500480
250-0480
2500480
Caterpillar 2500480 BATTERY
Weight: 63 pounds 28 kg.

Buy BATTERY 2500480 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

U and SU Three-Position Tilt Brace
If equipped:
Illustration 1 g03855019Pin the brace in the EXTENDED position and extend the right cylinder in order to tip the bulldozer blade forward.Pin the brace in the RETRACTED position and retract the right cylinder in order to tip the bulldozer blade rearward.
Illustration 2 g02082015
(N) Neutral
(E) Extended
(R) Retracted
Position the machine on a hard flat surface and lower the bulldozer blade to the ground. Place the bulldozer control in the FLOAT position. Engage the parking brake. Remove the retainer bolts and plates.
Activate the bulldozer tilt in the FLOAT position in order to remove the force from the tilt brace so that the rear pin for the tilt brace can be removed later. Shut down the engine, leaving the bulldozer control in FLOAT and the parking brake engaged.
Illustration 3 g02254613
Place a wood block between the tilt brace and the push arm. The block should measure at least 216 mm (8.5 inch) by 216 mm (8.5 inch) by 153 mm (6.0 inch). The block will help maintain the hole alignment between the tilt brace and the push arm when the pin is being removed.
Remove the pin at the tilt brace to the joint of the push arm.
Illustration 4 g02254615
Start the machine and activate the bulldozer tilt control in the FLOAT position. The tilt brace will slide forward or the tilt brace slides rearward on the push arm. Extending the cylinder will slide the brace forward. Retracting the cylinder will slide the brace rearward. Align the holes in the tilt brace and the push arm bracket and assemble the pin to the desired location. Alignment of the push arm may require the rotation of the push arm, if clearances at the joint allow rotation.
Shut down the machine. Return the bulldozer control to the HOLD position. Keep the parking brake engaged.
Reinstall the retainer bolts and the retainer plate. Note: The pin in the right arm to tilt cylinder is retained on the side toward the track, and the pin in the left arm to the tilt brace is retained on the outside.Angling the Blade
If equipped:
Illustration 5 g01017216The bulldozer blade can be positioned to various angles with the following instructions.
Use the lift cylinders to position the bulldozer blade with the edges and the end bits 25 to 50 mm (1 to 2 inch) off the ground.
Remove the bolts from the retainer pin (One on each side).
Remove the retainer pins.
Pull the coupling pin out of the housing.
Position the bulldozer blade at the desired angle.
Install the coupling pins in the new positions.
Install the retainer pins.
Install the bolts.


Parts battery Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.