BATTERY GP 4774550 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00583098
Loosen hose clamps (1) and remove breather tube (2) from the engine.
Illustration 2 g00583101
Remove three cap nuts (3), the washers and the rubber seals.
Remove valve mechanism cover (4) and the gasket from the engine.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Check the condition of the gasket and the rubber seals. If the gasket or the rubber seals are worn or damaged, use new parts for replacement.
Illustration 3 g00583101
Put the gasket and valve mechanism cover (4) in position on the engine.
Lubricate cap nuts (3) with clean engine oil. Install the rubber seals, the washers and cap nuts (3) .Note: Do not overtighten the cap nuts on the valve mechanism cover.
Tighten cap nuts (3) to a torque of 11 N m (8 lb ft).
Illustration 4 g00583098
Put breather tube (2) in position on the engine and tighten hose clamps (1) .