BATTERY & WIRING GP 6T3604 - Caterpillar

Automatic Temperature Control (ATC) - Fault Codes: (only for 584 Forwarders and 584HD Forwarders) Troubleshooting
Illustration 1 g01912574To display fault codes, depress the ON key three times in rapid succession. The digital display will then display any active fault codes. Pressing the ON key again repeatedly will scroll through any existing error codes. After five seconds without further key presses, the system will exit the diagnostics mode and return to normal operation.No Faults - E0Cab Sensor Shorted - E1Cab Sensor Open - E2Evaporator Probe Shorted - E3Evaporator Probe Open - E4Duct Sensor Shorted - E5Duct Sensor Open - E6Pressure Transducer Open - E151Pressure Transducer Shorted - E12Water Valve Actuator Error - E13Electronics or Comm. Error - E17Clutch Open - E18*Clutch Shorted - E19*No Refrigerant - E20*High-pressure - E22*Low Voltage Error - E23** Future implementationAdvanced Diagnostics:
The ATC Advanced Diagnostics control panel allows the technician to see real-time system information on the control panel display. Control panel display will assist in A/C-heater servicing. This real-time information can help the service technician diagnose certain system problems.To display advanced diagnostics, depress ON key three times in rapid succession (fault codes displayed) then immediately press and hold ON key for five seconds. The text "CAB" will be displayed. After a few seconds, the real-time value of the cab temperature measured by the ATC is displayed. This value, as well as any other value displayed by the control panel, will continuously update. Pressing the ON key again repeatedly will scroll through all of the available diagnostics informationCAB - Cab Air Temperature (°C or °F)EVAP - Evaporator Core Temperature (°C or °F)DUCT - Duct Air Temperature (°C or °F)HEAT - Water Valve Command (% of valve open)A-C - A-C Clutch Request (on / off )FAN - Blower Fan Speed (% of maximum fan speed)DEF - Defrost Mode Active (On/Off)HI-P - High Side Pressure (psig or bar)PRHT - Blower Enable Active (On/Off)VOLT - System Voltage (DC Volts)Note: The system can be operated normally while in advanced diagnostics mode, including changing the temperature set point or changing the blower fan speed, to evaluate the response of the system.Firmware Version Mode
The firmware version of the control panel and Electronic Control Unit (ECU) can be displayed. From the advanced diagnostics mode, press and hold the ON key for five seconds. The text CTRL will be displayed and after a few seconds, the control panel firmware version number will be displayed. Pressing the ON key will toggle to the ECU firmware version.The following firmware version information is available:CTRL - Control Panel VersionECU - ECU VersionExiting the Diagnostic Mode:
To exit the advanced diagnostic mode or firmware Version mode, turn the system OFF by pressing the OFF key.Additional Troubleshooting:
No Display
Turn on control panel with the ON key.
Check to see if the display Illuminates.
Verify that the control panel is plugged into the wire harness.
Check to see if wire harness is wired into vehicle properly.No Fan
Turn up fan with the fan UP key.
Make sure that the fan is plugged into wire harness, verify all wiring connections.
Verify