BEAM AS 1306461 - Caterpillar

Table 2
Contact Description J2 (1)    
No. (2)    Function    Type    
1     Key Switch Start     Voltage    
2     Implement Shutoff Solenoid     Current    
3     LH Service/Parking Brake Dump Solenoid     Current    
4     Load Return     Ground    
5     RH Service Secondary Brake Dump Solenoid     Current    
6     Backup Alarm     Voltage    
7     Neutral Start Relay     Voltage    
8     Load Return 2     Ground    
22     Digital Return     Ground    
23     Steering Filter Bypass Switch     Voltage    
24     Steering Lever Position Sensor 1     Pulse Width Modulation    
25     Steering Lever Position Sensor 2     Pulse Width Modulation    
26     Steering Lever Position Sensor 3     Pulse Width Modulation    
28     Upshift Sw (N.O.)     Voltage    
29     Upshift Sw (N.C.)     Voltage    
30     Downshift Sw (N.O.)     Voltage    
31     Downshift Sw (N.C.)     Voltage    
32     Right Service Brake Pedal Position Sensor     Pulse Width Modulation    
33     Direction Lever (FNR) Position Sensor     Pulse Width Modulation    
34     Steering Motor Speed Sensor 1     Frequency    
35     Steering Motor Speed Sensor 2     Frequency    
36     Forward Switch (N.O.)     Voltage    
37     Forward Switch (N.C.)     Voltage    
40     Left Service Brake Pedal Position Sensor     Pulse Width Modulation    
46     Implement Lockout Switch (N.C.)     Voltage    
47     Implement Lockout Switch (N.O.)     Voltage    
55     Harness Code 0     Ground    
58     Harness Code 1     Ground    
59     Harness Code 2     Ground    
60     Harness Code 3     Ground    
61     Harness Code 4     Ground    
67     CAN A+     Data Link    
68     CAN A-     Data Link    
( 1 ) The ECM responds to an active input only when all the necessary conditions are satisfied.
( 2 ) The connector contacts that are not listed are not used.