BEAM-BLADE-LH. 4B5804 - Caterpillar

Illustration 12 g02143667
Use a suitable press to install carrier shaft (14) in impeller (12) .
Install spacer (24) over shaft (14) .
Illustration 13 g02139427
Install freewheel cam (23), freewheel springs (22), freewheel rollers (21), and bearing race (20) in stator (17) .Note: If necessary, raise the temperature of stator (17) to a maximum temperature of 135 °C (275 °F). Install the cam with the IMPELLER SIDE facing downward. Continue with the installation until freewheel cam (23) contacts the retaining ring (not shown).Note: Install freewheel springs (22) with the maximum number of loops toward the outside diameter of freewheel cam (23) .
Illustration 14 g02139419
Install washer (19) and retaining ring (18) on stator (17). Repeat the procedure for the opposite side of stator (17) .
Illustration 15 g02139426
Install stator (17) on impeller (12) .
Install spacer (16) and retaining ring (15) on carrier shaft (14) .
Illustration 16 g02140513
Assemble carrier shaft (14), as follows.
Install ring (40) on shaft (39) .
Use a suitable press in order to install inner race (41) onto shaft (39) .
Install outer bearing (42) .
Use Tooling (B), Tooling (D), and a suitable press to install shaft assembly (39) and outer bearing (42) into carrier shaft (14) .
Install plate (43) and retaining ring (44) .
Illustration 17 g02139413
Install impeller (12) on rotating housing (13). The weight of the impeller assembly (12) is approximately 36 kg (80 lb).
Install bolts (11) and washers. The torque for bolts (11) is 60 7 N m (44 5 lb ft).
Illustration 18 g02139410
Use Tooling (B) to install bearing (10) in pump drive gear (9) .
Illustration 19 g02139394
Use Tooling (A) and a suitable lifting device to install the torque converter housing over the torque converter. The weight of the torque converter housing is approximately 100 kg (220 lb).
Illustration 20 g02139389
Install pump drive gear (9) and drive gear shaft (8) .
Install bolt (7) and the washer that holds drive gear shaft (8) to the torque converter housing. The torque for bolt (7) is 240 40 N m (180 30 lb ft).
Illustration 21 g02143681
Install pump drive flange (6) and bolts (6A). The torque for bolts (6A) is 60 12 N m (44 9 lb ft).
Illustration 22 g02139369
Install bolts (4) and the washers that hold the torque converter to the torque converter housing. The torque for bolts (4) is 50 10 N m (37 7 lb ft).
Install O-ring seal (5) .
Illustration 23 g02143713
Install gear (3). The torque for bolt (3A) is 120 20 N m (90 15 lb ft).
Install torque converter speed sensor (2), the seal, and the washer. Adjust torque converter speed sensor (2) in order to maintain an air gap of 0.71 0.18 mm (0.028 0.007 inch). The torque for torque converter speed sensor (4) is 25 5 N m (18 4 lb ft).End By: Connect the torque converter to the transmission and to the output transfer gears.