BEARING 0829223 - Caterpillar

Table 1
Compartment     Recommended Oil Change Interval     Recommended Sampling Interval     Sampling Valve     Oil Type    
Engine     250 Hours (1)     250 Hours     Yes     DEO    
Eccentric Weight Housing     3000 Hours     250 Hours     No     Synthetic ISO 220    
Hydraulics     1000 Hours (1)     250 Hours     Yes     HYDO    
Axle Oil     1000 Hours     500 Hours     No     MTO    
Final Drive Planetary (Axle)     1000 Hours     500 Hours     No     MTO    
Vibratory Support     1000 Hours     500 Hours     No     GO    
Drum Support     1000 Hours     500 Hours     No     GO    
Final Drive Planetary (Drum)     1000 Hours     500 Hours     No     Synthetic ISO 220    
( 1 ) Change both the oil and the oil filter.Consult your Caterpillar dealer for complete information and assistance in establishing an S O S program for your equipment.More Frequent S O S Sampling Improves Life Cycle Management
Traditionally, the suggested S O S sampling intervals have been at each oil change, 250 hours for engines, or every 500 hours for all other compartments. Under the following conditions, a sampling interval of 250 hours is recommended for all compartments.Application
A 500 hour sampling interval may not give an advance notice of failures in some high load conditions and in some high temperature conditions. A 250 hour sampling interval provides more data between oil change intervals. This increases the chance for detecting a possible failure.Determining Optimal Oil Change Intervals
Sampling compartments at every 250 hours provides information on oil performance in order to determine the best utility of a particular oil. Sampling more often can allow closer monitoring of component wear rates. For detailed information on extending oil change intervals, please see your Caterpillar dealer.Optimizing The Component Life Cycle
A decreased sampling interval provides better trends of data. A decreased sampling interval enables close monitoring of wear patterns on components. This will ensure full component life.Location of the Sampling Valves
Illustration 1 g00675893
The oil sampling valve for the engine oil is located on the left side of the engine.
Illustration 2 g00676490
The oil sampling valve is located on the vibratory manifold. The vibratory manifold is attached to the front of the hydraulic tank.