BEARING 0829714 - Caterpillar

At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Refer to Special Publication, SEBU6250, "Caterpillar Machine Fluids Recommendations", "Cooling System Specifications" for all cooling system requirements.
Excessive additive (greater than the recommended 6% initial fill) together with concentrations of antifreeze greater than 60% cause deposits to form and can result in radiator tube blockage and overheating.
Use 8T-5296 Test Kit in order to check the concentration.Liquid Supplemental Coolant Additive
Stop the engine. Allow the cooling system to completely cool.
Illustration 1 g00708494
Open the door to the engine compartment.
Illustration 2 g00708501
Slowly loosen the cooling system pressure cap in order to relieve system pressure. Remove the cooling system pressure cap.Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.
If necessary, drain enough coolant from the radiator in order to allow the addition of the liquid coolant additive.
Add 0.24 Liters (.50 pint) of cooling system additive for every 38 Liters (10 US Gallons) of engine cooling capacity.
Inspect the gasket for the cooling system pressure cap. Replace the cap if the gasket is damaged.
Install the cooling system pressure cap.
Close the door to the engine compartment.