BEARING-CONNECTING ROD 1039686 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-3931     Anti-Seize Compound     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01039879
Illustration 2 g01031557
Loosen V-band clamps (6) enough to allow compressor housing (5) and turbine housing (8) to rotate.
Apply Tooling (A) to manifold bolts (4) on the turbocharger. Attach a suitable lifting device to turbocharger (1). The weight of the turbocharger is approximately 34 kg (75 lb). Position turbocharger (1) on the engine.
Align compressor housing (5), cartridge assembly (7), and turbine housing (8). Install bolts (4) in the turbocharger and the manifold. Do not tighten bolts completely.
Tighten V-band clamp (6) for the turbine housing to a torque of 14 3 N m (10 2 lb ft).
Tighten manifold bolts (4) to 55 5 N m (41 4 lb ft).
Position compressor housing (5) so the air outlet is zero degrees from top vertical.
Install V-band clamp (6) for the compressor housing to 90 10 degrees outboard from the bottom vertical.
Tighten V-band clamp (6) for the compressor housing. Tighten the nuts to a torque of 14 3 N m (10 2 lb ft). Use a soft hammer to lightly hit around the diameter of V-band clamps (6) .
Illustration 3 g01031556
Install tube assemblies (2) and (3) to turbocharger (1) .