BEARING 1116144 - Caterpillar

Table 1
Required Tools    
Part Number    Description    Qty    
    Stopwatch     1    
    Scale
150 mm (6 inch)     1    
Illustration 1 g00657402
Place the machine on a slope of 12 degrees. The surface of the slope must be hard and smooth.
Extend the stick cylinder and the bucket cylinder.
The bucket should be empty.
Position the pin at the bucket cylinder rod end at a height of 800 mm (31 inch) from the ground.
Illustration 2 g00297498
To indicate the machine's relative position to the slope, put a mark on both the track and the ground. Refer to Illustration 2.
Stop the engine.
Measure the machine movement on the slope after three minutes.
Table 2
Drift mm (inch)    
New    Rebuild    Service Limit    
0     0     0