BEARING-SLEEVE 1170847 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system to a level below the water temperature regulator, into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct draining procedure.
Illustration 1 g02723915
Remove bolts (2) from water temperature regulator housing (1). Remove water temperature regulator elbow (1) and the gasket.
Illustration 2 g02723917
Illustration 3 g02723918
Remove water temperature regulator (3) from the water temperature regulator housing. Note: Note the orientation of the water temperature regulator elbow.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install water temperature regulator (3) in the reverse order of removal. installed.
Replace the thermostat cover gasket with a new one. Apply a liquid gasket of Loctite High Flex Form to the thermostat side only.
Check the water temperature regulator for correct operation. Refer to System Operation, Testing and Adjusting, "Water Temperature Regulator - Test" for the correct procedure to test the water temperature regulator. If any components of the water temperature regulator housing are worn or damaged, the complete assembly must be replaced.