BEARING AS-NEEDLE 1324292 - Caterpillar

Product Identification Number (PIN)
Illustration 1 g02145375
The Product Information Plate is located at the right rear corner of the machine.Service Information Number (SIN)____________________Product Information Number (PIN)____________________Year of manufacture ____________________
Illustration 2 g02212954
The Engine Serial Number and the Engine Information Plate is on the right side of the engine.
Table 1
Engine Serial Number, Engine Information, and Governor Information Plate    
Engine Serial Number        
Engine Information        Certification
European Union
Illustration 3 g01880193
This plate is positioned on the bottom left side of the plate for the PIN.Note: The CE plate is on machines that are certified to the European Union requirements that were effective at that time.For machines compliant to 2006/42/EC, the following information is stamped onto the CE plate. For quick reference, record this information in the spaces that are provided below.
Engine Power Primary Engine (kW)____________________
Engine Power for Additional Engine (If Equipped) ____________________
Typical Machine Operating Weight for European Market (kg)____________________
Year of Construction____________________
Machine Type ____________________For the name and address of the manufacturer, and the country of origin of the machine, refer to the PIN plate.For the manufacturer name and address and the country of origin, see the PIN plate.Sound Certification
Illustration 4 g00933634
A typical example of this film is shown. Your machine may have a different value.If equipped, the certification film is used to verify the environmental sound certification of the machine. The value that is listed on the film indicates the guaranteed sound power level. The guaranteed sound power level is measured at the time of manufacture. The guaranteed sound power level is measured according to the conditions that are specified in "ISO 6394:1998".Product Link
If equipped, this message is used to verify the certification of the Product Link as an RF transmitter. The following specifications are provided to aid in ensuring compliance with all local regulations:
Table 2
Operating frequency range     148 to 150 MHz    
Transmitter power     5 w    This message is located on the control group for the Product Link. The control group is located on the top of the cab.
Illustration 5 g01261742
This machine is equipped with a Caterpillar Product Link radio communication device which must be deactivated within 6.0 m (20 ft) of a blast zone. Failure to do so could result in serious injury or death.
If the machine is required to work within 6 m (20 ft) of a blast area, power to the Product Link module must be disconnected.Consult your Caterpillar dealer with any questions that concern the operation of the Product Link in a specific country.