parts catalog

BEARING KIT 1400041 - Caterpillar

1400041 BEARING KIT Caterpillar parts BEARING
Alternative (cross code) number:
Caterpillar 1400041 BEARING KIT
Weight: 45 pounds 20 kg.

Buy BEARING KIT 1400041 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


1. Remove the cotter pins from the pins at each end of the tie rod. Loosen nuts (1) and (3) until they are even with the bottom of the pins.2. Hit the nuts with a hammer to break the pins loose from their tapers. Remove nuts (1) and (3).3. Remove steering tie rod (2).Install Steering Tie Rod
1. Put steering tie rod (4) in position on the wheel spindle housing. Install the nuts on pins (3) and (5). Tighten the nuts to a torque of 150 lb.ft. (203 N m). Tighten the nut more if needed to put the cotter pin groove (slot) in the nut in alignment with the hole in the pin. Install the cotter pins.2. Make a toe-in adjustment to the front wheels at locations (1) and (2). Make an adjustment of the lengths of the rods in the steering cylinders when the toe-in for the front wheels is correct. See SPECIFICATIONS FOR 16G MOTOR GRADER HYDRAULIC SYSTEM AND STEERING, Form No. REGO1470-03 for the correct procedures.

Parts bearing Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.