BEARING-CONNECTING ROD 1428615 - Caterpillar

Removal Procedure
Start By:
Remove the fuel tank. Refer to Disassembly and Assembly, "Fuel Tank - Remove" for the machine that is being serviced.Refer to Disassembly and Assembly Manual, RENR1788 for the removal of the fuel tank.Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g00566680
Disconnect the three tube assemblies (1), (2) and (3) from the valve assembly.
Illustration 2 g00566681
Pull the front panel (4) out of the way.
Illustration 3 g00566682
Loosen nut (7). Remove adjusting sleeve (6). Remove the brake rod (8) on the side of the cab at the brake valve.
One person must hold the brake valve outside the cab and another person must hold the brake valve inside the cab in order to remove two bolts and washers (5). Remove the brake valve from the front of the cab.