BEARING 1513546 - Caterpillar

Assembly Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement. Lubricate the O-ring seals with the lubricant that is being used.
Illustration 1 g00865690
Install valve (9) into body (5) .
Illustration 2 g00865648
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install spring (8) into body (5) .
Install O-ring (6) on stopper (7) .
Illustration 3 g00865635
Install cover (1) on body (5) .
Illustration 4 g00865623
Install four bolts (4) in cover (1) .End By: Install the cooler bypass relief valve. Refer to Disassembly and Assembly, "Relief Valve (Cooler Bypass and Back Pressure) - Install".