BEARING AS 1574431 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Brackets     4    
B     1U-9202     Lever Puller Hoist     1    
C     1P-2420     Transmission Repair Stand     1    
F     1U-8846     Gasket Sealant     -    
Illustration 1 g01266709
Install bearing (36) into gear (34) .
Illustration 2 g01266697
Install thrust discs (35). Install gear (34) .
Illustration 3 g01265950
Install shaft (33). Install bolt (32) .
Illustration 4 g01266612
Install O-ring seal (31), cover (30), and bolts (29) .
Illustration 5 g01266763
Raise the temperature of bearings (28). Install bearings (28) onto gear (26) .
Illustration 6 g01265924
Install O-ring seal (27) and gear (26) onto adapter (24) .
Illustration 7 g01266820
Install gear (26) and adapter (24). Install bolts (25) .
Illustration 8 g01265910
Use Tooling (A), Tooling (B), and a suitable lifting device in order to reposition case assembly (23). The weight of case assembly (23) is approximately 365 kg (800 lb). Apply Tooling (F) to case assembly (23). Install case assembly (23) .
Illustration 9 g01265880
Install tube assembly (22) .
Illustration 10 g01265863
Install tube assembly (21). Install bolt (20) .
Install shims (19) and retainer (18). Install bolts (17) .Note: If new bearings are installed, check the end play of the shaft assembly. Refer to Disassembly and Assembly, "Transmission - Assemble".
Repeat Step 11 for the other retainers.
Illustration 11 g01265831
Use two people in order to install gear assembly (16). The weight of gear assembly (16) is approximately 30 kg (70 lb).
Illustration 12 g01265829
Use two people in order to install gear (15). The weight of gear (15) is approximately 23 kg (50 lb). Install retainer (14) and bolt (13) .
Illustration 13 g01265805
Apply Tooling (F) to cover assembly (9) .
Use Tooling (A) and a suitable lifting device in order to install cover assembly (9). The weight of cover assembly (9) is approximately 60 kg (130 lb).
Check the end play of the shaft assembly. Refer to Disassembly and Assembly, "Transmission - Assemble".
Position harness assembly (12) .
Install bracket assemblies (11) and bolts (10) .
Illustration 14 g01265795
Install O-ring seal (5). Install yoke (8), retainer (7), and bolt (6) .
Illustration 15 g01265775
Illustration 16 g01265774
Use Tooling (A), Tooling (B), and a suitable lifting device in order to reposition transmission (4). The weight of transmission (4) is approximately 1315 kg (2900 lb).
Illustration 17 g01265765
Install Electronic Control Module (3) and bolts (2) .
Connect harness assemblies (1) .End By: Install the input speed sensor. Refer to Disassembly and Assembly, "Speed Sensor (Transmission) - Install".