BEARING 1772500 - Caterpillar

Illustration 1 g00498290
Location of the pulled unit control position sensorThe pulled unit control position sensor is located on the left side of the operator's seat. The pulled unit control position sensor is a Pulse Width Modulated position sensor. The pulled unit control position sensor sends duty cycle signals to the Power Train Electronic Control Module (Power Train ECM).When the pulled unit control is used, the pulled unit control position sensor sends an electrical signal to the Power Train Electronic Control Module (Power Train ECM). The Power Train ECM uses this signal to energize the appropriate pulled unit proportioning solenoid on the pulled unit control valve. These pulled unit proportioning solenoids will move the spool in the pulled unit control valve. This will cause oil to be sent to the pulled unit in order to move the hydraulics.The signal from the pulled unit control position sensor is also used to neutralize the transmission. The Power Train ECM will allow only a forward speed position or the NEUTRAL position when the pulled unit control position sensor is in the OPEN position. The Power Train ECM will not allow a shift to the REVERSE position until the pulled unit control position sensor has been moved from the OPEN position and the transmission shift lever is in the NEUTRAL position.Note: If the machine is in REVERSE and the pulled unit control position sensor is in the OPEN position the Power Train ECM will shift the transmission to NEUTRAL. The machine will remain in NEUTRAL until the pulled unit control is moved into the HOLD or the FLOAT position and the transmission control has been cycled through NEUTRAL.