BEARING AS 1980856 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     185-3630     Strap Wrench As     1    
ZZ     6V-9508     Face Seal Plug     1    
6V-9829 Cap As     1    
6V-9507 Face Seal Plug     1    
6V-9828 Cap As     1    Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00917929
Use Tooling (A) in order to remove fuel filter (5). Refer to Operation and Maintenance Manual, "Fuel System Secondary Filter - Replace" for the correct procedure.
Remove bolts (4). Remove fuel priming pump (2) and the adapter.
Disconnect harness assemblies (1) .
Disconnect hose assemblies (3) .
Illustration 2 g00917935
Remove bolts (6) and remove fuel filter base (7) .Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 3 g00917935
Install fuel filter base (7) and install bolts (6) .
Illustration 4 g00917929
Connect hose assemblies (3) .
Connect harness assemblies (1) .
Install fuel priming pump (2) and the adapter. Install bolts (4) .
Install fuel filter (5). Refer to Operation and Maintenance Manual, "Fuel System Secondary Filter - Replace" for the correct procedure.