BEARING 1H3136 - Caterpillar

Illustration 38 g01291283
Install port plate (28) .
Illustration 39 g01292011
Install head (3) and bolts (2) .
Remove bolts (2) and head (3) .
Illustration 40 g01292006
Remove barrel (32) onto piston (41) .
Illustration 41 g01292559
Measure the Dimension (Z) .
Subtract the lift-off dimension from Dimension (Z) to obtain the correct shim thickness. The lift-off dimension is 0.25 to 0.40 mm (0.010 to 0.016 inch).
Illustration 42 g01292005
Illustration 43 g01292013
Remove bolts (40) and plate (42) .
Install pistons (39) and plate (42) .
Apply Tooling (N) to bolts (40). Install bolts (40). Tighten bolts (40) to a torque of 38 4 N m (28 3 lb ft).
Install spring (33) into piston (41) .
Illustration 44 g01292015
Install shim (34) into barrel (32) .
Illustration 45 g01291295
Install barrel (32) and O-ring seal (31) .
Illustration 46 g01291287
Install the O-ring seals, plug (25), plug (22), and plug (23) .
Install valve (24) and bolts (21). Tighten bolts (21) to a torque of 75 N m (55 lb ft).
Illustration 47 g01291284
Install O-ring seal (17), pin (12), nut (13), solenoid (14), nut (20), bushing (18), piston (19), dowel (10), spring (15), retainer (16), spring (7), retainer (9), spring (8), and bushing (11) .
Illustration 48 g01291286
Install O-ring seals (6) .
Illustration 49 g01291282
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install valve assembly (5) and bolts (4). Tighten bolts (4) to a torque of 25 N m (221 lb in).
Illustration 50 g01291279
Install head (3) and bolts (2). Tighten bolts (2) to a torque of 87 N m (64 lb ft).End By: Install the track drive motor.