BEARING 1T0736 - Caterpillar

Engine: All 3600 Engines All C280 EnginesIntroduction
Do not perform any of the following procedure until you have read and understand all of the information. The following procedure explains the operation of the Intellifast® Ultrasonic IHS Reader. The Intellifast Ultrasonic IHS Reader is used to measure the load on the 369-7181 Bolt As , connecting rod bolt.Parts Needed
Table 1 contains the part numbers needed for these instructions.Note: A computer is also needed for this torque tool group to operate.
Table 1
Qty    Part Number    Part Description    
1     438-3338     Torque Tool Gp    
Illustration 1 g03681996
(1) Data Acquisition Unit (DAU) (2) Software Compact Disc (3) Battery charger (4) Ethernet cable (5) Measurement head (6) Temperature probeInstallation
Illustration 2 g03677434
(1) WLAN green indicator light (2) Power button (3) DAU
Push and hold the "POWER" button (2) on the DAU (3). Watch for the WLAN green indicator light (1) to flash.
Illustration 3 g03686036
Push the reader button (4) and watch for the three red indicator lights (5) to turn on.
Illustration 4 g03684932
Connect to the DAU wireless network.
Power on the computer.
Click on the wireless network utility.
Click on "MyWLAN" to connect.
If unable to connect to "MyWLAN", use an ethernet cable for connection between DAU and the computer.
Illustration 5 g03677483
Click on the "Intellifast" icon on the desktop.
Illustration 6 g03677522
Enter your name into the "Username" field and click "OK".
Illustration 7 g03677535
Click on the "Cable Calibration" tab.
Illustration 8 g03686083
To configure the cable, click the "Configuration" tab. Illustration 8 will appear, prompting removal of the contact pin from the sensor for calibration of the measurement cable. Click the "OK" tab.
The "Cable Calibration" tab will change from red to green once calibrated.
Illustration 9 g03677832
If the inspection head is configured properly, there will be a green check mark in the box. If there is a red "X" in the box, click the red "X" to change to a green check mark. If the inspection head will not properly configure, start over at Step 1.
Verify that the "COM-Port" field valve is "6".
Verify that the "Pt 100" field is a red "X". This field is for manual temperature inputs.Note: A red "X" indicates that the inspection head is using the provided temperature probe. If the temperature probe is damaged or not being used, the red "X" should be clicked to display a green check mark. The temperature of the connecting rod should be obtained with an infrared temperature gun. The value is then put into the "Pt 100" field for the most accurate results. The "Pt 100" should contain a number and never be left blank.