BEARING 2089008 - Caterpillar

Illustration 26 g00827547
Select the "Product ID" selection that is displayed on the "Configuration" screen.
Click on the "Change" button that is located on the "Configuration" screen. This will display a dialog box.
Illustration 27 g00827548
Enter the "Product ID" of the machine. The "Product ID" must have 8 digits. The "Product ID" must be formatted as 3 alphanumeric characters and 5 numbers (8 digits). Refer to item 4 in Illustration 28.Note: The First Quarter of 2001, the Caterpillar Product Identification Number (PIN) changed from 8 characters to 17 characters. The "Product ID" that is required by the Machine Security System is Item (4) in Illustration 28.
Illustration 28 g00860618
(1) Caterpillar World Manufacturing Code (characters 1 - 3). (2) Machine descriptor (characters 4 - 8) (3) Check character (character 9) (4) Machine Indicator Section (MIS) or Product Sequence Number (characters 10 - 17). These characters were previously referred to as the Serial Number.
Click on the "OK" button. This will cause the Cat ET to display the following message.
Illustration 29 g00827549
Click on the "Yes" button to change the "Product ID" or click on the "No" button to cancel the change.If you enter an invalid "Product ID", the Cat ET will display the following message:
Illustration 30 g00827550
Set the Time and the Date
It is necessary to set the correct time and the date for the Machine Security System. Use the following procedure to set the time and the date.
Connect the Cat ET to the service connector via the communication adapter.
Place the Master Access Level Key into the key start switch and turn the key to the ON position.
Start the Cat ET.
Click on the "Connect" icon in the menu bar of the Cat ET.
Once the Cat ET has established communications with the MSS ECM, select the "ECM date/time" option from the "Service" menu. This will cause the Cat ET to display the following screen.
Illustration 31 g00827585
Press the "Change" button.
Illustration 32 g00827586
Enter the correct time and the date and press the "OK" button. Then, the Cat ET will display the following message.
Illustration 33 g00827587
Click on the "Yes" button in order to change the date/time clock or click on the "No" button in order to cancel the change.
Perform the ""Operational Check"".Operational Check
Place a valid electronic key in the key start switch.
Turn the electronic key to the ON position until the green LED indicator turns ON.
Turn the key to the START position. The machine should start.
Turn the key to the OFF position.
Turn the disconnect switch to the "OFF" position.
Reassemble all of the remaining parts and covers.
Turn the disconnect switch to the "ON" position.
Attach Special Instruction, RMHS1002, "Operation of the Machine Security System (MSS) " of the correct language to the machine's Operation and Maintenance Manual with the double sided tape that is provided.
Attach the Machine Security System film on the door of the machine or on the ROPS near the mount and dismount location of the operator.Troubleshooting
The machine fails to start
Indicator light does not turn on
Verify that all connections are tight.Check the indicator light.Indicator light remains red
The indicator is red for five seconds after attempting to start the