BEARING-CONNECTING ROD 2170586 - Caterpillar

Uninterruptible Power Supply: UPS 250 (S/N: APZ1-UP) UPS 300 (S/N: CNJ1-UP) UPS 120 (S/N: CNK1-UP) UPS 150 (S/N: CPC1-UP)Introduction
This Special Instruction provides the handling and unpacking instructions for the Uninterrupted Power System (UPS). The manual contains important safety instructions for the Clean-Source Uninterruptible Power System. These instructions should be followed during the operation and maintenance of the flywheel energy storage system.Do not perform any procedure in this special instruction until you have read this special instruction and understand this information.
The flywheel is shipped with bearing retainers that are installed in order to relieve the bearing of transient forces that may be encountered during shipping and handling. Do not attempt to remove the retainers or operate the unit until the unit is properly bolted to the floor anchors. The bearing retainers are to be removed only by Caterpillar authorized service personnel during the final inspection and before initial pre-startup.
Damage to the flywheel units can occur if the rotor for the flywheel is turning during the process of moving the unit.Do not move the flywheel units without the bearing retainers installed.
Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly. Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Ensure that any tool, procedure, work method, or operating technique you use that is not recommended by Caterpillar is safe.Handling Instruction
Crushing Hazard. Use extreme care when handling this equipment due to the uneven weight distribution of the cabinets. Locate the center of gravity symbols. Lift the cabinets only in the locations that are shown. Test the lift and balance the cabinets before transporting the cabinets. Maintain a minimum tilt from vertical at all times. Use a suitable material handling device in order to move the cabinets to the final destination. If a forklift is used, it must have a minimum capacity of 3 tons. The forks must have a width of 520.70 mm (20.50 inches) but needs to be less than 609.60 mm (24.00 inches). Failure to adhere to this warning can result in personal injury or death.
Do not lift the cabinet from the left side of the cabinet. Damage can occur to the cabinet if the cabinet is lifted from the left side.
Note: Keep the UPS unit dry during shipping, during storage, and during operation.
Illustration 1 g01179456
(1) Skid (2) Wood Blocks (3) Foam (4) KickplateThe Uninterruptible Power Supply (UPS) system is attached to