AVSPARE.COM
parts catalog

BEARING SET- 2389297 - Caterpillar



2389297 BEARING SET- Caterpillar parts BEARING
Rating:
56
Alternative (cross code) number:
CA2389297
238-9297
2389297
Caterpillar 2389297 BEARING SET-
Weight: 2 pounds 0 kg.

Buy BEARING SET- 2389297 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Installation Procedure
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Note: This installation procedure is effective for the following pilot valves: dozer and ripper.
Illustration 1 g00807173
Install cartridge valves (21) .
Illustration 2 g00807172
Install plate (20) . Install adapter (19) and tighten to a torque of 45 5 N m (33 4 lb ft). Install bolts (18) that lie diagonally.
Illustration 3 g00807170
Install rings (16) . Position magnet (17) .
Illustration 4 g00807169
Install control lever assembly (15) , shims (14) , and bolts (13) . Tighten the bolts to a torque of 20 3 N m (15 2 lb ft).
Illustration 5 g00807168
Install detent plate (12) . Install bolts (11) and tighten to a torque of 20 3 N m (15 2 lb ft).The following procedure is for the adjustment of the plate.
Illustration 6 g00809122
Move control lever (15) to FLOAT position.
Add or subtract shims (14) under plate (12) . The pointed edge of Detent Assembly (C) must ride on the upper side of the ramp of plate (12) in FLOAT, as shown. Refer to Detail (B) in Illustration 6.Note: The control lever (15) must pop back into NEUTRAL position when the pilot hydraulics are locked out.
If control lever (15) does not return to NEUTRAL, inspect the spring and the pointed edge of Detent Assembly (C) . Replace the components, as needed.
Repeat Steps 5.a to 5.c.
Illustration 7 g00807167
Install rubber boot (10) and lever lock plate (9) . Install bolts (8) that lie diagonally. Tighten the bolts to a torque of 12 3 N m (106 27 lb in).
Illustration 8 g00807157
Install console (7) . Connect speed mode switch (6) and tighten the bracket. Install the following components: rings (5) , joystick control (4) , horn button (3) (not shown), lockout control (2) and armrest (1) .


Parts bearing Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.