BEARING AS 2408240 - Caterpillar

(1),(10) Torque for nuts on the drum shaft ... 150 20 N m (110 15 lb ft)(2) Use 7M7260 Liquid Gasket Material on the faces between the retainer and drum assembly.(4) Torque for six bolts ... 55 7 N m (41 5 lb ft)(5) Torque for nine bolts that fasten the bull gear to drum ... 475 50 N m (350 37 lb ft)(6) Use 5P3413 Sealant on bolt threads.(8) Use shims as required to obtain 0.08 to 0.13 mm (.003 to .005 in) bearing end play.(9) Use 5P3413 Sealant on threads and torque four bolts to ... 45 7 N m (33 5 lb ft)Adjustment Of Winch Drum
1. Put the O-ring seal and washer in position on drum shaft and tighten nut (1) to ... 150 20 N m (110 15 lb ft)2. Put flange (3) in position with the O-ring seal but without the shims.3. Put O-ring seal and washer in position and tighten nut (10) to 150 20 N m (110 15 lb ft) to seat the bearing.4. Measure the gap between the case and flange (3) with a feeler gauge in four places around the flange.5. Make a note of the average measurement.6. Loosen nut (10) and flange (3).7. Install the amount of shims (7) (the same thickness as the gap measured in Step 4) between flange (3) and the case.8. Align the holes in flange (3) with the holes in the case and install bolts (6) finger tight.9. Tighten nut (10) to ... 150 20 N m (110 15 lb ft)10. Tighten bolts (6) to ... 45 7 N m (33 5 lb ft)54 And 55 Winches (Later)
(1),(20) Torque for nuts on the drum shaft ... 150 20 N m (110 15 lb ft)(2) Use 7M7260 Liquid Gasket Material on the faces between the retainer and drive assembly.(4) Torque for six bolts ... 55 7 N m (41 5 lb ft)(5) Torque for nine bolts that fasten ball gear to drum ... 475 50 N m (350 37 lb ft)(6) Use 5P3413 Sealant on bolt threads(8) Use shims as required to obtain 0.08 to 0.13 mm (.003 to .005 in) bearing end play(9) 6P9547 Spring Free length after test ... 44.45 mm (1.75 in)Outside diameter ... 24.61 mm (.969 in)(11) 9W4332 Springs (three equally spaced) Length under test force ... 27.5 mm (1.08 in)Test force ... 40 2 N (9 .5 lb)Free length after test ... 44.25 mm (1.74 in)Outside diameter ... 10.50 mm (.413 in)(12) Use 5P3413 Sealant on bolt threads(13) Use the 7M7260 Liquid Gasket Material between the boss and the case assembly.(14) Use shims as required to center fork assembly (18) in coupler (12).(15) Use 5P3413 Sealant on threads and torque four bolts to ... 55 7 N m (41 5 lb ft)(16) 7W0134 Spring Length under test force ... 33.67 mm (1.326 in)Test