2419999 BEARING-SLEEVE Caterpillar parts
315C, 315D L, 318C, 319C
Rating:
Alternative (cross code) number:
CA2419999
241-9999
2419999
CA2419999
241-9999
2419999
Weight: 3 pounds 1 kg.
Information:
ID
90.17
mm
OD
106.136
mm
WIDTH
90
mm
EXCAVATOR,
You can buy:
US$59.99
28 May 2025
FridayParts
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
Number on catalog scheme:
For full view, you need register
Information:
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Do not loosen the fuel lines at the fuel manifold. The fittings may be damaged and/or a loss of priming pressure may occur when the fuel lines are loosened.
Prime the fuel system in order to fill the fuel filter, and prime the fuel system in order to purge trapped air. The fuel system should be primed under the following conditions:
The fuel tank is running low.
The machine has been stored.
The fuel filter is being replaced.Machines with a Mechanical Priming Pump
Open the engine hood.
Illustration 1 g01355833
Priming Pump Plunger
Turn the priming pump plunger counterclockwise in order to unlock the priming pump plunger. Operate the priming pump plunger until a strong pressure is felt. This procedure will require considerable strokes.
Push in the priming pump plunger and tighten the priming pump plunger by hand.
Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking the engine again.
Crank the engine. If the engine does not start or if the engine misfires, additional priming is required. Also if the engine emits smoke, additional priming is required.
If the engine starts but the engine runs rough, continue to run the engine at low idle. Run the engine at low idle until the engine runs properly.
Check the fuel system for leaks. Stop the engine.
Close the engine hood. Machines with an Electrical Priming Pump
Illustration 2 g01355838
(1) Switch for the fuel priming pump
(2) Primary fuel filter/water separator The switch for the fuel priming pump is located by the primary fuel filter/water separator.
Open the front access door on the right side of the machine.
Hold the switch for the fuel priming pump in the ON position. Allow the fuel priming pump to run for several seconds.
Return the switch for the fuel priming pump to the OFF position.
Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking the engine again.
Start the engine. If you cannot start the engine, the engine needs more priming. If the engine continues to misfire or to smoke, more priming is necessary. Note: The fuel priming pump will only operate if the engine start switch key is in the OFF position. Shut off the engine before any additional priming.
Run the engine at the LOW IDLE position until the engine runs smoothly.
Check the fuel system for leaks. Stop the engine.
Close the access
Caterpillar parts catalog:
Parts bearing Caterpillar catalog:
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 318C, 318E L, 319C, 319D, 319D L, 319D LN, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320...
315D L, 316E L, 318C, 318D L, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320B L, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, ...
315D L, 316E L, 318C, 318D L, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320B L, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, ...
318C, 319C, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 321C, 321D LCR, 322C, 322...
318C, 319C, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321C, 321D LCR, 322C, 322C FM, 323D L, 323D LN, 323D SA, 324D, 324D FM, 324D FM LL, 324D L, 3...
1190, 1190T, 1290T, 2290, 2390, 2391, 2491, 318B, 318C, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320E LN, 321D LCR, 323D L, 323D LN, 323D SA, 323E L, 325B L, 325C, 325D L, 330B L, 330C, 330D L,...
1390, 318C, 319C, 320B, 320C, 321C, 322C, 322C FM, 345C, 541, 551, 552, TK741, TK751, TK752
318C, 318E L, 319C, 319D, 319D L, 319D LN, 320C, 321C, 321D LCR, 322B L, 322B LN, 323D L, 323D LN, 325B L, 325C, 328D LCR, 330C, 330C FM, 330C L, 330C MH, 330D, 330D FM, 330D L, 330D LN, 330D MH, 336D...
311D LRR, 312C L, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D L, 319D LN, 320C, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LRR, 320D RR, 321D LCR, 323D L, 323D LN, 323D SA
311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321D LCR, 323D L, 323D LN, 323D SA
311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321D LCR, 323D L, 323D LN, 323D SA
311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321D LCR, 323D L, 323D LN, 323D SA
318C, 318E L, 319C, 319D, 319D L, 319D LN, 320C, 321C, 321D LCR, 322B L, 322B LN, 323D L, 323D LN, 325B L, 325C, 328D LCR, 330C, 330C FM, 330C L, 330C MH, 330D, 330D FM, 330D L, 330D LN, 330D MH, 336D...
1390, 318C, 319C, 320B, 320C, 321C, 322C, 322C FM, 345C, 541, 551, 552, TK741, TK751, TK752
1985509
BEARING-SLEEVE
318C, 319C
318C, 319C
1190, 1190T, 1290T, 2290, 2390, 2391, 2491, 318B, 318C, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320E LN, 321D LCR, 323D L, 323D LN, 323D SA, 323E L, 325B L, 325C, 325D L, 330B L, 330C, 330D L,...
2064991
BEARING-SLEEVE
318C, 319C, 320C
318C, 319C, 320C
1715956
BEARING
318C, 319D, 319D L, 319D LN, 320C, 320D, 320D L, 320D LRR, 320D RR, 320D2 L, 321C, 321D LCR, 322C, 323D L, 323D2 L, 325B L, 325C, 328D LCR, 330B L, 330C L, PIN GRAB
318C, 319D, 319D L, 319D LN, 320C, 320D, 320D L, 320D LRR, 320D RR, 320D2 L, 321C, 321D LCR, 322C, 323D L, 323D2 L, 325B L, 325C, 328D LCR, 330B L, 330C L, PIN GRAB
2071676
BEARING
303
303
1992368
BEARING
302.5C, 303, 304, 305
302.5C, 303, 304, 305
1992164
BEARING GP-MAIN
302.5C, 303
302.5C, 303
1708767
BEARING
304.5, 305.5, 306
304.5, 305.5, 306
1807557
BEARING-SLEEVE
314C, 315C
314C, 315C