BEARING AS 2435321 - Caterpillar

Removal Procedure
Note: This removal procedure is for engines with a configuration of triple oil coolers.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Remove the water temperature regulator housing.
Drain the oil from the oil coolers.
Illustration 1 g00608642
This is an Illustration of a typical installation.
Remove the plug from the oil cooler bonnet in order to drain the coolant from the oil coolers.
Disconnect the water temperature contactor assembly (if equipped) from the oil outlet cover.
Remove two tubes (1). Note: The electrical connections and other variations in the models could require additional removals or disconnections before you remove the component.
Attach a strap and a hoist to the oil cooler (2). Remove sixteen bolts and a P-clamp. Remove the oil cooler (2). The weight of the oil cooler assembly is 136 kg (302 lb).
Remove the tube (3) and the other tube (5).
Remove the tube (6).
Remove the tube (8) and the tube assembly (9) (not shown).
Attach a strap and a hoist to the oil coolers (4). Remove the bolts (7). Remove the coolers and the oil temperature regulator housing (10). The weight of the oil cooler assembly is 262 kg (582 lb).