BEARING-ROLLER 2692431 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Note: Put identification marks on all tube assemblies for installation purposes. Plug all tube assemblies. This helps to prevent fluid loss, and helps to keep contaminants from entering the system.
Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (DEAC) - Change" or Operation and Maintenance Manual, "Cooling System Extended Life Coolant - Change" for the proper procedure.
Illustration 1 g02363359
Remove panel (1).
Illustration 2 g02363360
Disconnect hose assemblies (2), (3) and (4).
Illustration 3 g02363361
Disconnect tube assemblies (5) and (6). Remove bolts (7) in order to remove transmission oil cooler (8) and the seal from the machine.
Illustration 4 g03357062
Note orientation of diverter valve (9) for installation purposes.