BEARING 2B2953 - Caterpillar

Removal Procedure
Disconnect batteries before performance of any service work.
Note: Before disconnecting the wires and electrical cables, mark the items for the proper connections in order to ensure correct assembly.
Illustration 1 g00597378
Disconnect the wires and electrical cables from solenoid (1) and starting motor (2). If the engine has two starting motors, disconnect the wires between the two solenoids and starting motors.
Attach a suitable hoist to the starting motor. The starting motor weighs approximately 30 kg (66 lb).
Remove three bolts (3). Remove the starting motor. Remove the gasket from the joint between the starting motor and the flywheel housing. Installation Procedure
Inspect the gasket for the joint between the starting motor and the flywheel housing. Obtain a new gasket, if necessary.
Attach a suitable hoist to the starting motor. The starting motor weighs approximately 30 kg (66 lb).
Illustration 2 g00597378
Place the gasket in the cover for the starting motor. Lift the starting motor onto the mounting position. Install three bolts (3).
Connect the wires and electrical cables to solenoid (1) and starting motor (2). If the engine has two starting motors, connect the wires between the two solenoids and starting motors.