BEARING 2D6530 - Caterpillar

Note: Refer to the Guideline for Reusable Parts, SEBF8002 or refer to the Guideline for Reusable Parts, SEBF8034 for the necessary procedures and specifications for checking used valves and valve springs.
Illustration 1 g01443249
(1) 7S-7144 Spring (new spring for the valves) Length under test force ... 44.86 mm (1.766 inch) Test force ... 257 25 N (57.7 4.5 lb) The "use again" minimum load at the length under test force ... 217 N (48.8 lb) Length of the spring at the valve open position ... 32.28 mm (1.271 inch) The "use again" minimum load at the valve open position ... 658 N (148.5 lb) Free length after test ... 52.07 mm (2.050 inch) Outside diameter ... 35.22 mm (1.387 inch) Do not bend the spring more than the following value. ... 1.82 mm (0.072 inch) (A) Height to the top of the valve guide ... 22.23 0.25 mm (0.875 0.010 inch) (B) New valve stem Diameter of the new valve stem ... 9.441 0.008 mm (0.3717 0.0003 inch) The "use again" minimum diameter ... 9.408 mm (0.3704 inch)Bore in the valve guide for the guide that is installed in the head New minimum distance ... 9.478 mm (0.3731 inch) Worn maximum distance ... 9.581 mm (0.3772 inch) (C) Valve lip thickness which is the distance between the taper seat (diameter) and the valve face The minimum "use again" distance for the exhaust valve ... 2.18 mm (0.086 inch) The minimum "use again" distance for the inlet valve ... 1.75 mm (0.069 inch) (D) Diameter of the valve head Exhaust valve ... 48.16 0.13 mm (1.896 0.005 inch) Inlet valve ... 51.31 0.13 mm (2.020 0.005) (E) Angle of the valve face ... 60.75 0.25 degrees
Illustration 2 g01439813
(F) Depth of the bore in the head for the valve seat insert ... 12.28 0.13 mm (0.483 0.005 inch) (G) Valve seat insert Diameter of the valve seat insert for the exhaust valve ... 50.889 0.013 mm (2.0035 0.0005 inch) Bore in the head for the valve seat insert for the exhaust valve ... 50.813 0.030 mm (2.0005 0.0012 inch) Diameter of the valve seat insert for the inlet valve ... 52.032 0.013 mm (2.0485 0.0005 inch) Bore in the head for the valve seat insert for the inlet valve ... 51.956 0.030 mm (2.0455 0.0012 inch) (H) Angle of the face of the valve seat insert ... 30 1 degrees (I) Width of the valve seat for the inlet valve and the exhaust valve Maximum permissible width ... 1.93 mm (0.076 inch) Minimum permissible width ... 1.14 mm (0.045 inch) (J) Dimension from the top of the closed valve to the face of the head Minimum permissible dimension for the exhaust valve ... 0.66 mm (0.026 inch) Minimum permissible dimension for the inlet valve ... 0.15 mm (0.006 inch) (K) Outside diameter of the face of the valve seat insert