BEARING 2H2330 - Caterpillar

Description
Illustration 1 g01272741
(1) Door
(2) Door pull
Illustration 2 g01272776
Interior view of door pull and ring
(3) Door latch
(4) C shaped retaining ring A pull for the door (2) is located in the UPS system. Refer to Illustration 1 for a representative location. The pull for the door (2) is a circular black plastic cylinder that is a fitted assembly through a hole in the door (1). The pull for the door (2) is held in place by a C shaped retaining ring (4).Removal Procedure
Open the cabinet door (1) by turning the two door locks that are located at the top and bottom right of the door. Use a hex key.
Locate the C shaped retaining ring (4) that is located on the back side of the door (1). The retaining ring holds the door pull (2) to the door (1). Refer to Illustration 2.
Spread the C shaped ring (4) open. Remove the ring.
Slide the door pull (2) straight outward from the front of the side door (1). Installation Procedure
Open the cabinet door (1) and locate the hole near the middle of the door (1) on the right side.
Retrieve the new door pull (2) and insert the door pull flat side first into the hole from the front of the door (1).
Spread the C shaped retaining ring (4) and slip the ring over the door pull from the back side of the door (1).
Seat the door pull (2) firmly against the door (1) so that a groove is visible all the way around the cylinder.
Release the spreader so that the C shaped ring (4) firmly seats in the groove.