BEARING AND LINK ASSEM. 2V0708 - Caterpillar

Description
Each electronic gauge module can be programmed. The various functions that may be performed by programming and their corresponding access codes are shown in Table 1 below. Programming Mode-Entering
To enter the programming mode, press and hold the three buttons on a module simultaneously. When the three buttons are making contact, the module will display "prog" as shown below. It is not necessary to press the buttons hard. When the module detects that the three buttons are making contact, the display will show "prog".The buttons must be held and the module must display "prog" continuously for 3 seconds. If the display of "prog" is flickering, the buttons are not being pressed continuously. After 3 seconds, the module's display will change from "prog" to "C0" for 1/2 second as shown below. The three buttons may be released once the module displays "CO". After the module displays "C0" for 1/2 second, the display will switch to "0000". The zero on the left will be flashing. The display "0000" represents code 0000 from Table 1. The modules enter the programming mode displaying code 0000. Any code from Table 1 may now be entered.Programming Code-Change
Modules enter the programming mode displaying code "0000". The left zero will be flashing. The left and right buttons allow a new code to be entered.Each time the right button is pressed and released, the value of the flashing digit will increment. The flashing digit will wrap around from 9 to 0. If the right button is held for more than 1 second, all four digits will reset to 0.Digit selection is made by pressing the left button. Each time the left button is pressed and released, the next digit to the right will become the flashing digit.The center button is used to enter a new code. The button is held until the display changes from "C0". Example:The electronic gauge modules can display readings in metric (kPa/°C) or English (psi/°F). To convert from metric to English, enter the programming mode and change the programming code to 7000. When the center button is held to enter the new code, the display will show "C0" for 1/2 second and then it will return to the normal display mode. To convert from English to metric, enter the programming mode and enter code 6000.Viewing Constant and Flag Values
Chart 5 in the Reference Charts section of this manual lists all of the constant and flag values stored in each module. There is a separate chart for each module. The constants are listed first followed by the flags. The following three types of constants are stored in each module:* Alarm Setpoints* Shutdown Setpoints* Calibration SetpointsTo view the constant and flag values in a module, enter the programming mode (see topic Programming Mode-Entering in this section). The module will enter the programming mode displaying "0000" which represents code 0000 from Table 1. Code 0000 allows the constant and flag values to be viewed so the code will not need changed.Press the middle button momentarily and release