BEARING 3106157 - Caterpillar

3406 (90U, 91U, 92U),
3408 (67U, 99U, 28V, 48W),
3412 (38S, 60M) The schematic shows the parts in the ether starting aid group and their approximate location. Parts shown are as follows: 5P2948 Connector (1), Ether Valve (2), 7N2059 Clamp (3), 6N5899 Temperature Switch (4), 6N9587 Connector (5), 7N8132 Switch (6), 2L8075 Terminal (7), 5P5623 Wire (8), Ether Atomizer (9), 7N140 Flexible Coupling (10), 8N3536 Tube (11), Ether Cylinder (A) (not part of a group - must order separately), Cylinder Head (B), Control Panel or Dash (C), Wiring to Battery (D), Inlet Manifold (E).This instruction gives the installation procedure for 12V, 24V and 30/32V ether starting aid groups for 3400 Series Engines. At installation of the atomizer, it is important that it be installed with the identification mark in a specific position. Use the index to find the installation instructions, by engine model, that are needed.Aftercooler Cover - 3408 Engines
For those 3408 Engines that are equipped with a 4N5832 Cover (1) for the aftercooler, either drill hole (A) to 11.0Ø (.43"Ø) and make 1/4"-18 pipe threads in the hole, or install an 8N1000 Cover as a replacement. If hole (A) is made larger for the 1/4"-18 threads in a 4N5832 Cover, remove the cover from the engine before this work is done. After the hole is drilled and the new threads are made, inspect the area around the hole for possible cracks or damage.Installation Procedure
(1) Put 5P2948 Connector (1) in ether valve (2). Install ether valve (2) in a good location, as follows: A. Install in a vertical position that is within the angle limit shown.B. As near the engine manifold as possible, but not on the engine.C. Do not install the ether valve in a location where the temperature is more than 93°C (200°F).(2) Install 7N2059 Clamp (3) directly above ether valve (2) according to the dimension shown. According to the ether starting air group that is to be installed, the part number of the atomizer will be either 6N7672 or 6N9995, and will look like item (9) in one of the above illustrations. When either atomizer is installed on an engine, the arrow [(F) or (G)] must be put in a specific position for each engine model. This instruction gives the correct position of the arrow for all engines.It is necessary to remove a 1/4" pipe plug from the air inlet system of the engine to install an atomizer (9). A 6N5899 Temperature Switch must also be installed, after a 3/8" pipe plug is removed from the cylinder head. See the information that follows for the location of the plugs to remove for installation of the temperature switch and an atomizer (9).3406 Turbocharged - Industrial, Marine, Marine Auxiliary, Truck
TOP VIEW
REAR VIEW(1) Inlet manifold, (2) cylinder head, (A)