BEARING 3249501 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
C 9S-8864 Plate 1
D 1P-0510 Driver Gp 1
Illustration 1 g02736756
Raise the temperature of ring gear (20). Use a suitable press and Tooling (C) to install ring gear (20) onto the housing. Install ring gear (20).
Illustration 2 g02736436
Install thrust washer (19).
Illustration 3 g02736396
Install thrust washer (18).
Illustration 4 g02736356
Install axle bevel gear (17).
Illustration 5 g02736317
Install bearings (15) and bearings (13). Install spider gears (14) and long spider gear shaft (16).
Illustration 6 g02736563
Install spider gears (11) and short spider shafts (12). Drive spring pins (10) into short spider shafts (12).
Illustration 7 g02736787
Install axle bevel gear (9). Install thrust washer (8).
Illustration 8 g02736604
Install thrust washer (7) onto housing (5).
Illustration 9 g02737019
Install housing (5) and start bolts (4).
Raise the temperature of bearing cone (6). Install bearing cone (6).
Illustration 10 g06203841
Use a suitable press and Tooling (D) to secure the differential assembly. Tighten bolts (4) to a torque of 400 40 N.m (295 30 lb ft).
Illustration 11 g02737101
Install upper housing (2) and start bolts (1).
Raise the temperature of bearing cone (3). Install bearing cone (3).
Illustration 12 g06203838
Use a suitable lifting device to position the differential onto a suitable press. The weight of the differential is approximately 65 kg (143 lb). Use the suitable press and Tooling (D) to secure the differential. Tighten bolts (1) to a torque of 185.0 18.5 N.m (136.4 13.6 lb ft).End By:
Install the rear differential.