AVSPARE.COM
parts catalog

BEARING AS-TAPERED ROLLER 3499848 - Caterpillar


3499848 BEARING AS-TAPERED ROLLER Caterpillar parts 416D, 420D, 420E, 424D, 428D, 430D, 430E, 432D, 442D
Rating:
57
Alternative (cross code) number:
CA3499848
349-9848
3499848
Caterpillar 3499848 BEARING AS-TAPERED ROLLER
Weight: 1 pounds 0 kg.

Buy BEARING AS-TAPERED ROLLER 3499848 Caterpillar genuine, new aftermarket tractor parts with delivery
BACKHOE LOADER,

Compatible equipment models: 3499848:

BACKHOE LOADER  416D   420D   420E   424D   428D   430D   430E   432D   442D   Caterpillar
Number on catalog scheme: 2
  For full view, you need register

Information:


Personal injury or death can result if two persons are not used in the following procedure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Machine Preparation
Prepare the machine for testing by completing the procedure that is specified in the Service Manual module Testing and Adjusting, "Machine Preparation for Troubleshooting" for the machine that is being serviced.Test Procedure
Brake service life can vary greatly because of the different applications. The following conditions can lead to premature brake failure:
Check for oil leaks at the yoke and the drive axles. A leak can also allow contamination from water and debris to occur. Water and debris can enter the axle through the lip seal at the drive yoke. The water and debris can mix with the oil. This water and debris can lead to premature brake failure.
The axle housing breather may be plugged or damaged. Check the axle housing breather for proper operation.
Excessive heat can be generated if the service brakes are used as a retarder. Excessive heat can be generated if the service brakes are used as a device to maintain a slower ground speed. This type of operation should be avoided by using a lower transmission gear speed. Check the grooves on both sides of each disc in both the front and rear service brakes. The wear of the service brake disc may vary from one end of the machine to the other end, and from one side of the machine to the other side. The estimated wear for a given groove depth is shown in table 1.Also, it is very important to change the friction discs as soon as possible once the groove depth has reached the maximum wear limit. As the depth of the grooves is reduced, the flow of the cooling oil is reduced. This causes heat to build up. The heat causes the rapid wear of the disc material. Eventually, the friction material will wear off the disc. This will cause metal to metal contact between the disc and plates. This problem is known as spalling. The buildup of the friction material in the oil could cause damage to the very smooth surface finish of the plate. Spalling will destroy the very smooth surface finish of the plate. This will make replacement of these brake components necessary. If the failure has progressed to metal to metal contact, the complete axle must be thoroughly cleaned. This process of cleaning the axle must be done correctly, or the debris will continue to contaminate the oil. This will cause the material on the service brake disc to wear rapidly. This condition will cause premature failure of the

Caterpillar parts catalog:

Caterpillar parts catalog
OEMTCPLUS Transmission HZ400001-UP
OEMTPG115 Transmission H3300001-UP
OEMTCPLUS Transmission H3200001-UP
420D Backhoe Loader FDP07199-18399 (MACHINE) POWERED BY 3054 Engine
428D Backhoe Loader BLL00651-00712 (MACHINE) POWERED BY 3054 Engine
416D Backhoe Loader BGJ00523-01315 (MACHINE) POWERED BY 3054 Engine
420D Backhoe Loader BKC00502-UP (MACHINE) POWERED BY 3054 Engine
420D Backhoe Loader BMC00611-UP (MACHINE) POWERED BY 3054 Engine
420E Backhoe Loader Single Tilt Center Pivot HLS00001-UP (MACHINE) POWERED BY 3054C Engine
420E Backhoe Loader Parallel Lift Center Pivot KMW00001-UP (MACHINE) POWERED BY 3054C Engine
430E Backhoe Loader Center Pivot EAT00001-UP (MACHINE) POWERED BY 3054C Engine
430E Backhoe Loader Center Pivot DDT00001-UP (MACHINE) POWERED BY 3054C Engine
420D Backhoe Loader MBH00001-UP (MACHINE) POWERED BY 3054C Engine
442D Backhoe Loader SMJ00001-UP (MACHINE) POWERED BY 3054C Engine
424D Backhoe Loader CJZ00001-UP (MACHINE) POWERED BY 3054C Engine
428D Backhoe Loader BXC00001-UP (MACHINE) POWERED BY 3054C Engine
428D Backhoe Loader MBM00001-UP (MACHINE) POWERED BY 3054C Engine
432D Backhoe Loader TDR00001-UP (MACHINE) POWERED BY 3054C Engine
420D Backhoe Loader FDP18400-UP (MACHINE) POWERED BY 3054C Engine
420D Backhoe Loader BLN10300-UP (MACHINE) POWERED BY 3054C Engine
430D Backhoe Loader BNK05900-UP (MACHINE) POWERED BY 3054C Engine
430D Backhoe Loader BML04800-UP (MACHINE) POWERED BY 3054C Engine
450E Backhoe Loader Center Pivot EBL00001-UP (MACHINE) POWERED BY C4.4 Engine
420E Backhoe Loader Parallel Lift PHC00001-UP (MACHINE) POWERED BY C4.4 Engine
420E Backhoe Loader Single Tilt PRA00001-UP (MACHINE) POWERED BY C4.4 Engine
430E Backhoe Loader Parallel Lift SCD00001-UP (MACHINE) POWERED BY C4.4 Engine
430E Backhoe Loader Single Tilt RLN00001-UP (MACHINE) POWERED BY C4.4 Engine
420E Backhoe Loader Parallel Lift GAN00001-UP (MACHINE) POWERED BY 3054C Engine
420E Backhoe Loader GEK00001-UP (MACHINE)
420F2 Center Pivot Backhoe Loader LBS00001-UP (MACHINE) POWERED BY 3054C, C4.4 Engine
OEMTCPLUS Transmission HCN00001-UP


Parts bearing Caterpillar catalog:

2074263 BEARING AS
416D, 416E, 416F, 420D, 420E, 420F, 422E, 422F, 424D, 430D, 430E
2074267 BEARING AS
416D, 416E, 416F, 420D, 420E, 420F, 422E, 422F, 424D, 430D, 430E
2105932 BEARING-WHEEL
414E, 416D, 416E, 420D, 422E, 428E, 430D, 430E, 432E, 442E, 450E, 450F, CP-533E, CP-56, CP-573E, CS-533E, CS-54, CS-54B, CS-563E, CS-583E, CS-64, CS-74, TH220B, TH330B
3994731 BEARING
414E, 416D, 416E, 416F, 420D, 420E, 420F, 422E, 422F, 424D, 428D, 428E, 428F, 430D, 430E, 430F, 432D, 432E, 432F, 442D, 442E
2332614 BEARING
416D, 416E, 416F, 420D, 420E, 420F, 430D, 430E, 430F, 450E, 450F
2332613 BEARING
416D, 416E, 416F, 420D, 420E, 420F, 422E, 422F, 424D, 428D, 428E, 428F, 430D, 430E, 430F, 432D, 432E, 432F, 434E, 434F, 442D, 442E, 444E, 444F, 450E, 450F, 517, 527
2094232 BEARING
414E, 416E, 416F, 420E, 420F, 422E, 422F, 424B, 424B HD, 428E, 428F, 430E, 430F, 432E, 432F, 434E, 434F, 442E, 444E, 444F, CP-54B, CP-56, CP-573E, CP-64, CS-533E, CS-54, CS-54B, CS-56, CS-563D, CS-563...
2136702 BEARING-SLEEVE
416E, 416F, 420E, 420F, 422E, 422F, 428E, 428F, 430E, 430F, 432E, 432F, 434E, 434F, 442E, 444E, 444F
2627043 BEARING
416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E, 444E
2785454 BEARING-SLEEVE
416E, 416F, 420E, 420F, 422E, 428E, 432E, 434E
2787066 BEARING
416E, 420E, 420F, 430E, 430F, 432E, 442E, 924G, 924H, 924K, 928HZ, 930G, 930K, 938K
2136703 BEARING
416E, 420E, 420F, 422E, 422F, 428E, 428F, 430E, 432E, 432F, 434E, 434F, 442E, 444E, 444F
3499892 BEARING AS-TAPERED ROLLER
416D, 420D, 420E, 424D, 428D, 430D, 430E, 432D, 442D
3499891 BEARING AS-TAPERED ROLLER
416D, 420D, 420E, 424D, 428D, 430D, 430E, 432D, 442D
3888330 BEARING AS-TAPERED ROLLER
416D, 420D, 420E, 420F, 424D, 428D, 428F, 430D, 430E, 430F, 432D, 432E, 432F, 434E, 434F, 442D, 442E, 444F, 450E, 450F
3499875 BEARING AS-SHAFT
416D, 420D, 424D, 428D, 432D, 442D
1972853 BEARING
D6N, TH460B, TH560B
2748629 BEARING-NEEDLE
414E, 416E, 416F, 420E, 420F, 422E, 422F, 428E, 428F, 430E, 430F, 432E, 432F, 434E, 434F, 442E, 444E
2094232 BEARING
414E, 416E, 416F, 420E, 420F, 422E, 422F, 424B, 424B HD, 428E, 428F, 430E, 430F, 432E, 432F, 434E, 434F, 442E, 444E, 444F, CP-54B, CP-56, CP-573E, CP-64, CS-533E, CS-54, CS-54B, CS-56, CS-563D, CS-563...
2332613 BEARING
416D, 416E, 416F, 420D, 420E, 420F, 422E, 422F, 424D, 428D, 428E, 428F, 430D, 430E, 430F, 432D, 432E, 432F, 434E, 434F, 442D, 442E, 444E, 444F, 450E, 450F, 517, 527
2332614 BEARING
416D, 416E, 416F, 420D, 420E, 420F, 430D, 430E, 430F, 450E, 450F
3994731 BEARING
414E, 416D, 416E, 416F, 420D, 420E, 420F, 422E, 422F, 424D, 428D, 428E, 428F, 430D, 430E, 430F, 432D, 432E, 432F, 442D, 442E
3888364 BEARING AS-TAPERED ROLLER
416D, 420D, 424D, 428D, 432D, 442D
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.