BEARING-THRUST 3606838 - Caterpillar

Illustration 1 g00303463
Before you load the machine, chock the trailer wheels or the rail car wheels, as shown.The machine can be transported as a 3050 mm (10 ft) load, if the screed extensions are retracted within the screed. The end gates must be removed. The hopper wings must be raised and secured together in the up position.Raise the screed. Extend the tow arm supports.Raise the adjustable augers to the most upright position.
In order to avoid possible machine damage, back the machine onto the trailer.Ship the machine with the screed on blocks, and the tow arm cylinders fully retracted.Extendable screed must be parallel and inline before retracting.
Engage the parking brake.Stop the engine.Turn the start switch to the OFF position. Remove the start switch key.Turn the battery disconnect switch to the OFF position. Remove the disconnect switch key.Cover the exhaust opening or secure the rain cap in order to prevent the turbocharger from windmilling in transit.Lock the door and the access covers. Attach any vandalism protection.Chock the tracks. Secure the machine with tie-downs.
Rotation of the turbocharger without engine operation can result in damage to the turbocharger.Cover the exhaust opening or secure the rain cap in order to prevent the turbocharger from windmilling in transit.
After the machine is on the trailer, lower the screed onto blocks that support the screed fully across the width of the screed. Install the cover on the console. Cover the operator seat.Perform a walk-around inspection and measure the fluid levels in the various compartments.Travel at a moderate speed. Observe all speed limitations when you are roading the machine.