BEARING-RLR-YM 3807511 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7575     Link Bracket     2    Start By:
Remove the rocker arm and shaft. Refer to Disassembly and Assembly, "Rocker Arm and Shaft - Remove".
Remove the unit injectors. Refer to Disassembly and Assembly, "Unit Injector - Remove".
Remove the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
Remove the valve mechanism cover base. Refer to Disassembly and Assembly, "Valve Mechanism Cover Base - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".
Illustration 1 g01063034
Remove accessory drive group (1) .
Disconnect tube assemblies (3) and (4) .
Remove tube assembly (2) .
Disconnect hose (5) .
Illustration 2 g01142119
Disconnect hose assemblies (6) and (7) .
Disconnect the sensors.
Attach Tooling (A) and a suitable lifting device to cylinder head (9). The weight of cylinder head (9) is approximately 147 kg (325 lb).
Remove bolts (8). Remove cylinder head (9) and the gasket.