BEARING-INNER 3B8845 - Caterpillar

Shutdown mode prevents damage to the generator set when a shutdown fault is occurring. A shutdown fault is critical. When a shutdown fault occurs, the GSC+ automatically activates shutdown mode until the shutdown fault is corrected. The GSC+ shuts down the engine when the GSC+ is in shutdown mode. The GSC+ prevents starting of the engine and the GSC+ alerts the operator.The GSC+ alerts the operator and the GSC+ identifies the shutdown fault by FLASHING the corresponding shutdown indicator. The name of the shutdown indicator identifies the shutdown fault.Shutdown Indicators
Low oil pressure
Emergency stop
High water temperature
Engine overspeed
Engine overcrank
Fault shutdown
Spare 1, Spare 2 and Spare 3 accompanied by the fault shutdown indicatorIf the fault shutdown indicator is the only indicator FLASHING, additional information is available. A fault code is shown on the upper display which more precisely identifies the cause of the shutdown fault. See System Operation, "Fault Description" for more information.Shutdown Mode Sequence
A shutdown fault occurs and the GSC+ detects the shutdown fault.
To shut off the fuel, the GSC+ deactivates the fuel control relay (FCR).
In order to prevent the engine from starting, the GSC+ deactivates the run relay (RR), and the GSC+ deactivates the starting motor relay (SMR).
In order to remove the generator load, the GSC+ activates the genset fault relay (GFR). This activates the optional circuit breaker shunt trip coil.Note: The spare output may also be programmed to activate when a shutdown occurs. This output can drive a relay in order to open the circuit breaker, or the output can open a transfer switch. See System Operation, "Spare Input/Output Programming OP6".
When engine speed reaches 0 rpm, the GSC+ deactivates the crank termination relay (CTR). The electronic governor relay (EGR) is deactivated when the engine oil pressure reaches the setpoint P014 for low oil pressure shutdown at idle speed 70 kPa (10 psi).
The GSC+ FLASHES the corresponding shutdown indicator. If the fault shutdown indicator is FLASHING, a fault code is shown on the upper display. See Systems Operation, "Fault Description".
If the fault shutdown indicator is the only indicator FLASHING, additional information is available. A fault code is shown on the upper display that better identifies the cause of the shutdown fault. See the Systems Operation, "Fault Description".
The lower display continues to show the engine data.
The relay status indicators show.
K2 (GFR)
K7 (FCR) - (ETS fuel systems) for 70 seconds after engine speed decreases to 40 rpm and oil pressure decreases to 80 kPa (12 psi). (K7 is not shown for ETR fuel systems.)Engine Start Sequence After Shutdown
Correct the shutdown fault. See the System Operation, "Fault Identification".
Turning the engine control switch (ECS) to the OFF/RESET position resets the GSC+. If no shutdown fault is active, the GSC+ returns to normal mode and the engine is able to start.