BEARING 3D0083 - Caterpillar

Failure to comply to the rated load can cause possible personal injury or attachment damage. Review the rated load of a particular attachment before performing any operation. Make adjustments to the rated load as necessary.
Note: Rated loads should be used as a guide. Different work tools and poor ground conditions have effects on rated loads. The operator is responsible for being aware of these effects.Rated loads are based upon a standard machine with the following conditions:
Proper lubricants
Full fuel tank
Enclosed ROPS
80 kg (176 lb) operator
35/65-33 or equivalent tiresConsult your Caterpillar dealer about the rated load for a specific work tool.The rated operating load is defined by the SAE standard "J818" (May 1987) and by the ISO 5998 (1986) as 50 percent of the full turn static tipping load.The dump clearance and the reach are given for each bucket at maximum lift height and at a 45 degree dump angle. Clearance is measured from the ground to the bucket edge when the bucket is in the full DUMP position. The reach is measured from the front tire to the bucket edge.
Illustration 1 g00835725
Dimension (A) represents the dump clearance. Dimension (B) represents the reach.
The following table provides the rated operating loads for the standard machine configuration.
Table 1
Rated Load
986H Standard Machine Configuration
Ground Engaging Tools Rated Volume Rated Operating Load Dump Clearance
A Reach
B
Spade Rock with Teeth and Segments 6.1 m3 (8 yd3) 10000 kg (22046 lb) 3176 mm (125 inch) 2066 mm (81 inch)