BEARING 3G5750 - Caterpillar

Illustration 1 g01468567
Tightening sequence for engine oil pan
Illustration 2 g01468108
(1) The sealing surfaces must be free of oil, fuel, water, dirt and any other contaminants during assembly. Apply a continuous bead of 8T-9022 Silicone Gasket with a consistent cross section of 5.0 mm (0.20 inch). After assembly of the engine oil pan, remove excess sealant with a straight edge. The oil pan must be assembled and tightened to the cylinder block within five minutes of applying sealant.Use the following procedure to tighten the bolts for the oil pan:
Tighten the bolt 1 through bolt 40 in the numerical sequence to 47 9 N m (35 7 lb ft).
Tighten the bolt 41 through bolt 45 for the rear joint of the oil pan to 45 5 N m (33 4 lb ft).
Tighten the bolt 46 and bolt 47 for the rear joint of the oil pan to 25 6 N m (18 4 lb ft).
Tighten the bolt 48 through bolt 53 for the front joint of the oil pan to 45 5 N m (33 4 lb ft).
Tighten the bolt 54 and bolt 55 for the front joint of the oil pan to 25 6 N m (18 4 lb ft). (2) Torque for the drain adapter ... 96 15 N m (70 11 lb ft) (3) Torque for the liquid level switch ... 70 15 N m (50 11 lb ft)