BEARING-SLEEVE 3G6372 - Caterpillar

Separation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     9S-9082     Engine Turning Tool     1    
B     138-7574     Link Bracket     3    
C     1U-9200     Lever Puller Hoist     1    Start By:
Remove the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install" for the specified engine.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01327236
Use Tooling (A) in order to rotate the flywheel. Remove bolts (1) .
Illustration 2 g01417129
Attach Tooling (B), Tooling (C), and a suitable lifting device onto the torque converter and transmission (2). The weight of torque converter and transmission (2) is approximately 975 kg (2150 lb).Note: A torque converter and a transmission that is equipped with transfer gears weighs approximately 1405 kg (3100 lb).
Disconnect harness assembly (3). Remove bolts (4) .
Remove the torque converter and transmission (2) .