BEARING-RLR-YM 4174516 - Caterpillar

Removal Procedure
Start By:
Remove the left engine guard. Refer to Disassembly and Assembly, "Engine Side Guards - Remove and Install".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00742070
Remove fuel filter (4) from fuel filter base (5) .
Loosen clamp (2). Remove hose (3) from breather (1) .
Illustration 2 g00742071
Disconnect fuel lines (6) and (7) from fuel filter base (5) .
Illustration 3 g00742073
Remove mounting bolts (8) and remove fuel filter base (5) and the gasket.
Illustration 4 g00742076
Remove bolt (9), breather (1), and O-ring seal (10) from fuel filter base (5) .Installation Procedure
Note: Clean all of the mating surfaces. If necessary, replace the gasket.
Illustration 5 g00742076
Install O-ring seal (10), breather (1), and bolt (9) onto fuel filter base (5) .
Illustration 6 g00742073
Put fuel filter base (5) and the gasket in position. Install mounting bolts (8) .
Illustration 7 g00742071
Connect fuel lines (6) and (7) to fuel filter base (5) .
Illustration 8 g00742070
Connect hose (3) to breather (1). Tighten clamp (2) .
Install fuel filter (4) onto fuel filter base (5) .End By: Install the left engine guard. Refer to Disassembly and Assembly, "Engine Side Guards - Remove and Install".