BEARING 4423587 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Remove the engine oil cooler. Refer to Disassembly and Assembly, "Engine Oil Cooler Core - Remove".
Remove the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Note: Put identification on all lines, hoses, wires, and tubes for installation purposes. Use caps and plugs on all lines, hoses, and tubes in order to prevent fluid loss or contamination of the systems.
Illustration 1 g00793265
Disconnect water line (2) from transmission oil cooler (1) .
Illustration 2 g00793283
Remove the four bolts which hold tube assembly (3) in place. Loosen hose clamp (5) and remove tube assembly (3) .
Remove the four bolts which hold tube assembly (8) in place. Loosen hose clamp (7) and remove tube assembly (8) .
Remove the bolt which holds bracket (4) in place. Move bracket (4) and hoses (6) away from the transmission oil cooler.
Illustration 3 g00793269
Loosen hose clamp (9). Remove bolt (10) which holds tube (11) in place. Remove tube (11) .
Illustration 4 g00793296
Install Tooling (A) on transmission oil cooler (1), as shown. Attach a hoist and a suitable lifting device to Tooling (A) .
Remove four bolts (12) from transmission oil cooler (1) .
Remove four bolts (13) from transmission oil cooler (1) .
Remove transmission oil cooler (1). The weight of the transmission oil cooler is 68 kg (150 lb).