BEARING AS 4575671 - Caterpillar

Illustration 12 g03417474
Block (7) assembled to the machine
Locate the Right-Hand Side Plate As. from the Frame As. The Right-Hand Side Plate As. stops the Lift Arm during normal machine operation. Place Block (7) on top of the Plate As. Refer to Illustrations 11 and 12. Note: Ensure that Block (7) rests loosely on top of the Plate As. before lowering the Lift Arms to the down position.
Lower the Lift Arms until the Lift Arms reach the top of Block (7). The machine can now be driven on the road with the Lift Arms elevated at the required height above the ground. Refer to Operation and Maintenance Manual, SEBU9084, "Loader Lift Arm Brace Operation". Installing the Film Plate
Illustration 13 g03417475
(3) 258-3849 Identification Plate
Illustration 14 g03417674
(AA) 3 mm (0.12 inch)
Illustration 15 g03417476
Identification Plate (3) assembled to the machine
Install Identification Plate (3) to the front face of the Right-Hand Side Plate As. that stops the Lift Arms. Refer to Illustrations 13 and 15. Ensure that Identification Plate (3) is centered on the front face of the Plate As. and positioned approximately 3 mm (0.12 inch) (AA) below the welded section that joins the top and the front surfaces of the Plate As. Refer to the appropriate standards and specification for Film Placement if needed. Refer to Illustration 14. Installing the Mounting Bracket for the Horn
Note: For machine models 246D, 262D, 277D, 279D, 287D, and 289D, follow Steps 1 through 3. For machine models 272D, 272D2, 297D, 297D2, 299D, and 299D2, follow Step 4. For machine models 236D, 242D, 257D, and 259D, follow Step 5.
Illustration 16 g03758798
(15) 8T-4139 Bolt
(16) 8T-4223 Hard Washer
(17) 8T-4244 Nut
(18) 189-0852 Wiring Harness
(19) 453-2518 Plate
Install the 453-2518 Plate onto the Load Stop located on the left-hand side of the machine. Install the Plate in the