BEARING-CONE 4921963 - Caterpillar

Customer Parameters
"Equipment ID"
"Equipment ID" allows the customer to enter a description into the ECM in order to identify the vessel. A maximum of 17 characters may be entered in the field. This parameter is only for reference by the customer. This parameter is not required."Engine Serial Number"
"Engine Serial Number" must be programmed to match the engine serial number that is stamped on the engine information plate. If the ECM is replaced, the engine serial number must be programmed into the new ECM.Note: When you are requesting factory passwords, always use the engine serial number that is resident in the ECM."ECM Serial Number"
The "ECM Serial Number" is stored in the memory of the ECM. The "ECM Serial Number" can be accessed by the use of the service tool."Personality Module Part Number"
"Personality Module Part Number" is programmed into the software."Personality Module Release Date"
"Personality Module Release Date" is programmed into the software."Engine Rotation"
The "Engine Rotation" can be viewed only."Engine Location"
If multiple engines are installed, the parameter for the engine location identifies the locations of the engines."Full Load Setting (FLS)"
"FLS" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Factory passwords are required."Full Torque Setting (FTS)"
"FTS" is similar to "FLS". Factory passwords are required."High Idle Speed"
The "High Idle Speed" is programmed into the software."Low Idle Speed"
"Low Idle Speed" is the minimum allowable operating speed for the engine."Fuel Correction Factor"
The "Fuel Correction Factor" is a parameter that adjusts the calculation of fuel consumption. The fuel correction factor is used to correct the estimated fuel rate."Coolant Level Sensor"
The "Coolant Level Sensor" parameter can be set to the following status: "Not Installed", "Data Link" and "Sensor". If the sensor is available via the EMS panel in the engine control panel, set the status to the "Data Link". If the sensor is mounted on the engine, set the status to the "Sensor"."Torque Limit Enable Status"
The "Torque Limit Enable Status" enables the torque limit. "Maximum Engine Torque Limit"
The "Maximum Engine Torque Limit" and the range for the "Maximum Engine Torque Limit" is programmed into the software."Minimum Engine Torque Limit"
The "Minimum Engine Torque Limit" and the range for the "Minimum Engine Torque Limit" is programmed into the software."Coolant Warning Engine Load Enable Threshold"
The "Coolant Warning Engine Load Enable Threshold" is programmed in order to set the setpoint for low coolant."Air Shutoff Status"
This "Air Shutoff Status" enables the strategy for the air shutoff.Parameter Table
Table 2
Customer Parameters
Parameter ECM Default Range Password
"Equipment ID" Primary
Secondary N/A 17 alphanumeric characters No
"Engine Serial Number" Primary
Secondary 8 alphanumeric characters
#AA##### No
"ECM Serial Number" Primary
Secondary ECM Serial Number ECM Serial Number N/A
"Personality Module Part Number" Primary
Secondary N/A
"Personality Module Release Date" Primary
Secondary Month
Year N/A
"Engine Rotation" Primary
Secondary Forward Forward/Reverse N/A
"Engine Location" Primary Center Port
Center
Starboard No
"Full Load Setting (FLS)" Primary
Secondary Not Programmed −128 to +127 Yes
"Full Torque Setting (FTS)" Primary
Secondary 0 −128 to +127 Yes
"Rated Engine Speed"