BEARING 4B3673 - Caterpillar

Illustration 1 g03402750
Table 1
Specification for 381-3897 Oil Pan Gp
Item Qty Part Specification Description
1 - - As required, apply red Loctite 596 to the gasket joints before assembly.
2 5 1A-2029 Bolt Use the following procedure in order to tighten the bolts of the plate:
1. Tighten five bolts (2) to a standard torque.
2. Tighten bolt 1 through bolt 10 in a numerical sequence that is shown in Illustration 1 to a standard torque.
3 10 1A-2029 Bolt
Illustration 2 g03402755
Table 2
Item Qty Part Specification Description
4 - - Before assembly, as required apply red Loctite 596 on the connecting joint of the flywheel housing and the rear of the cylinder block.
Before assembly, as required apply red Loctite 596 on the connecting joint of the front accessory drive housing and the front of the cylinder block
5 50 5P-5855 Bolt As required, apply blue Loctite 242 to the open top end of the bolt holes after assembly of the oil pan.
6 2 3P-0654 O-Ring Seal Lubricate the bore of the O-ring seals lightly with the lubricant that is being sealed or an approved equivalent.
7 4 5P-5700 O-Ring Seal Lubricate the bore of the O-ring seals lightly with the lubricant that is being sealed or an approved equivalent.
8 2 6V-4315 O-Ring Seal Lubricate the bore of the O-ring seals lightly with the lubricant that is being sealed or an approved equivalent.
9 1 4B-2363 Oil Drain Plug Torque to 145 15 N m (107 11 lb ft).