BEARING-SLEEVE 4E2352 - Caterpillar

Fuel injection timing is set in the factory. Fuel injection timing can not change during operation.Note: If a fuel injection pump is removed, replace the old shims (1) with new shims (1) of the same thickness. Old shims (1) must not be reused.Note: If the thickness of the shim (1) is 0.5 mm (0.0197 inch) or the thickness of the shim (1) is below 0.5 mm (0.0197 inch), install beaded shims (1). If the shim thickness is above 0.5 mm (0.0197 inch), install the non-beaded shim. Then install the beaded shim (1). Ensure that the beading on the beaded shim (1) faces upward, toward the bottom of the fuel injection pump.
Illustration 1 g01334878On C2.2 engines, select the correct combination of shims from table 1.
Table 1
Shim Thickness (mm) Part Number Beaded
0.2 154-3017 Yes
0.3 160-3555 Yes
0.4 160-3556 Yes
0.5 160-3557 Yes
0.5 160-3558 No On C1.5 engines, select the correct combination of shims from table 2.
Table 2
Shim Thickness (mm) Part Number Beaded
0.2 236-4961 Yes
0.3 236-4959 Yes
0.4 236-4954 Yes
0.5 236-4952 Yes
0.5 160-7034 No On C0.7 engines, select the correct combination of shims from table 3.
Table 3
Shim Thickness (mm) Part Number Beaded
0.2 153-6385 Yes
0.3 161-1432 Yes
0.4 161-1433 Yes
0.5 161-1434 Yes
0.5 161-1435 No On C0.5 engines, select the correct combination of shims from table 4.
Table 4
Shim Thickness (mm) Part Number Beaded
0.2 290-9845 Yes
0.3 290-9844 Yes
0.4 290-9848 Yes
0.5 290-9847 Yes
0.5 290-9846 No On C1.6 engines, select the correct combination of shims from table 5.
Table 5
Shim Thickness (mm) Part Number Beaded
0.2 291-0922 Yes
0.3 291-0923 Yes
0.4 291-0924 Yes
0.5 291-0925 Yes
0.5 291-0926 No If the original shim thickness can not be determined, contact the Dealer Solution Network. The user must provide the full engine number of the product that is serviced.