BEARING 4Y9797 - Caterpillar

Unravel neutral wire (BA) and neutral wire (BB) from the circuit breaker assembly (30).
Assemble cable strap (26) through one slot of the harness tie down clip closest to the circuit breaker board and secure so the neutral wire bundle lays on the side near the circuit breaker board. As shown in Illustration27.
Unravel neutral wire (AY) and neutral wire (AZ) from the circuit breaker assembly (30) so the ring terminal can be assembled to the top left stud (BC) of the terminal block .
Assemble cable strap (26) through one slot of harness tie down clip closest to the circuit breaker board and secure the neutral and ground wires such that the wires lay on the side near the circuit breaker board. As shown in Illustration27.
Illustration 28 g03673331
Assemble cable strap (26) through both slots of the harness tie down clips and secure the neutral wire bundle.
Assemble the ring terminals to the top right stud (BC) of the terminal block use existing hardware and tighten stud to 10 2 N m (89 18 lb in).
Use existing hardware to secure ring terminals and tighten to 10 2 N m (89 18 lb in).
Assemble cable strap (26) through side of clip nearest the circuit breaker board and secure the neutral wires. As shown in Illustration28.
Route neutral wires (BD) to avoid rubbing on bracket .
Illustration 29 g03673344
Ensure neutral wires (BE) are assembled such that the wires do not extend above the generator electrical box (BF) and come in contact with the cover.
Illustration 30 g03673450
Assemble the wire harness ground ring terminals (BG) and the ground wire ring terminal (BH) to the block stud such that hard washer (19) separates the terminals and another wire harness ground ring terminals (BJ), hard washer (19), lock washer (17), nut (15) secure the stack up.
Tighten the nut to 25 6 N m (221 53 lb in).
Illustration 31 g03673480
(BK) 50 5 mm (2.0 0.2 inch)
(BL) 43 5 mm (1.7 0.2 inch)
(31) 421-4076 Film
Assemble film (31) decal to the bottom of the generator electrical box door per the dimensions shown. Clean surface to remove dirt, dust, grease, and oil.
Illustration 32 g03673517
(BP) 19 3 mm (0.7 0.1 inch)
(BR) 14 3 mm (0.6 0.1 inch)
(BS) 85 3 mm (3.3 0.11 inch)
(BT) 156 3 mm (6.1 0.1 inch)
(32) 7Y-8555 Seal
Remove knockouts (BM) in the circuit breaker cover plate (BN) which is mounted to the underside of the generator electrical box cover.
Remove knockout (BU) in the circuit breaker cover plate if the auxiliary power panel is installed.
Install seal (32) as per dimension shown in Illustration 32.
Illustration 33 g03674000
Install hydraulic motor (M) mount using existing hardware that were saved in Step 11.
Ensure that the Lovejoy coupler (W) is properly aligned.
Ensure to put the harness support bracket (BV) back on.
Reuse 1M-4543 Grommet (BW).
Illustration 34 g03674008
Route harnesses (BX) using previous routing provisions.
Illustration 35 g03674009
Install new cover 417-9515 Panel Cover Assembly (BY) using existing hardware that were saved in Step 1.
Reinstall 153 mm (6.0 inch) of seal