BEARING-CUP 5014307 - Caterpillar

Illustration 9 g00885497
Illustration 10 g00885498
Note: Mark the location of pistons for assembly purposes.
Remove plate (29) and pistons (30) from barrel (31). Remove retaining ball (32) .
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Illustration 11 g00885499
Illustration 12 g00885500
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Use Tooling (A) and a press in order to compress spring (34) until the snap ring (33) can be removed from barrel (31) with Tooling (B). Slowly release the pressure on the press because of the spring pressure. Remove barrel (31) from the press. Remove spring (34), retaining disc (35), and pressure pins (36) .
Illustration 13 g00885501
Remove plug (37) and the O-ring seal.
Illustration 14 g00885502
Remove piston (38) from housing (3) .
Illustration 15 g00885503
Note: The rod is engaged in the socket by the edges of the socket. Extreme care must be used in order to disengage the rod from the socket. Remove the actuator rod out of the smooth shaped socket.
Angle the swashplate (39) so rod (40) extends out of the bore. Remove rod (40) from the socket in swashplate (39) .
Illustration 16 g00885504
Remove swashplate (39) from housing (3). Check the condition of socket (41) .
Illustration 17 g00885505
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove spring (44) .
Remove socket head screws (42) and remove bearings (43) .
Illustration 18 g00885506
Lift shaft (24) out of the housing (3). If necessary, press bearing (43) off shaft (24).
Illustration 19 g00885534
Use Tooling (C) in order to remove snap ring (44) from housing (3) .
Illustration 20 g00885537
Remove seal (45) from housing (3) .