BEARING AS-FIX 5086923 - Caterpillar

Illustration 43 g01411363
(10) 310-8378 Cover As
Install cover (10). Start by removing the lock pin and by raising the grill for the RATAAC system. Position cover (10) so that the grill extends through the opening in the cover. Close the grill and install the lock pin. Then, seal edge (W) to the front edge of the grill. Next, seal edges (X) to the rear edge of the grill. Seal edge (Y) to the front edge of the radiator guard. Seal edges (Z) to the machine frame, as shown. See Illustration 43.Installing the two 312-2613 Cover As
Illustration 44 g01410297
The shape of the 312-2613 Cover As (12)
Illustration 45 g01410572
Pictorial view of the 312-2613 Cover As (12)
Illustration 46 g01410298
Inside view of the right tower that shows the installation of cover (12) (11) 311-6565 Bracket As (12) 312-2613 Cover As
Illustration 47 g01410308
The right tower plate is removed in this illustration for clarity in order to show the installation of cover (12) . (11) 311-6565 Bracket As (12) 312-25613 Cover As Note: Ensure that the mounting surface is clean and free of grease before you install this cover.
Install cover (12) inside the right tower. Install the cover by removing the protective paper strips from the tape strips and by pressing the tape strips in position. See Illustration 46.Note: Follow installation sequence of side (W), side (X), side (Y), and side (Z), as shown. See Illustration 47.Note: Do not remove the protective paper strip from more than one tape strip at a time in order to avoid contamination of the adhesive.
Illustration 48 g01410615
Inside view of the left tower that shows the installation of cover (12) (11) 311-6565 Bracket As (12) 312-2613 Cover As Note: Ensure that the mounting surface is clean and free of grease before you install this cover.
Use the instructions in the previous step and install cover (12) inside the left tower. See Illustration 48. Appendix
Modifying Seal (24A)
Illustration 49 g01407290
Remove areas that are shown in crosshatch from the "tongue side" of seal (24A). Seal (24A) is installed on the hinge side of the rear door. (A) 10.7 1.0 mm (0.42 0.04 inch) (B) 155 5 mm (6 0.2 inch) (C) 417 5 mm (16 0.2 inch) (D) 111 5 mm (4 0.2 inch) (Z) Tongue side of the sealModifying Seal (24B)
Illustration 50 g01406704
Remove areas that are shown in crosshatch from the tongue side of seal (24B). Seal (24B) is installed on the latch side of the rear door. (A) 10.7 1.0 mm (0.42 0.04 inch) (B) 223 5 mm (9 0.2 inch) (C) 415 5 mm (16 0.2 inch) (D) 80 5 mm (3 0.2 inch) (Z) Tongue side of the sealService Parts
Table 9
5P-7482 Seal (22) (1)
Service Part    
Quantity    Part Number    Description    
250 cm (98 inch)     5P-7483     Seal    
( 1 ) Nonserviceable Item