BEARING 5295043 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tools    Part Number    Part Description    Qty    
A     1P-1859     Retaining Ring Pliers     1    
B     8H-0663     Bearing Puller Gp     1    Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01383153
Install needle bearings (20) to housing (2), if necessary.
Illustration 2 g01383151
Use Tooling (B) in order to install bearing (17) to shaft (15) .
Install spacer (18) and shaft seal (19) to shaft (15) .
Illustration 3 g01383149
Illustration 4 g01383533
Use a suitable press to install shaft (15) onto housing (2) .
Use Tooling (A) to install retaining ring (16). Install woodruff key (14) to shaft (15).
Illustration 5 g01386225
Install bearings (13) to cover (6), if necessary. Install gasket (12) to cover (6) .
Illustration 6 g01383148
Install dowel pins (10) and (9) to cover (6) .
Install drive gear (8) and driven gear (11) to cover (6) .
Illustration 7 g01383145
Carefully connect cover (6) to housing (2) and install bolts (7). Tighten bolts (7) to a torque of 15 2 N m (132 18 lb in).
Illustration 8 g01383144
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install ball (3), spring (4), and screw (5) to housing (2). Tighten screw (5) to a torque of 18 2 N m (162 18 lb in).
Repeat Step 10 on screw (1) .End By: Install the gear motor (vibratory). Refer to Disassembly and Assembly, "Gear Motor (Vibratory) - Install".